CAD Library Creation and Maintenance

I offer a full CAD Library Creation and Maintenance service. New CAD libraries, parts, footprints, schematic symbols, 3D models, created from scratch or existing libraries updated.

Component Footprint/Land Pattern Creation

Footprint for an 0.80mm pitch 100-pin BGA

Footprint for an 0.80mm pitch 100-pin BGA

Component Footprints (or Component Land Patterns) are created to the existing IPC-7351B, or the upcoming IPC-7361C standard, manufacturer’s recommendations, or to the customer’s standards.

Footprint for an Hirose FX2-60P-1,27DSL connector

Footprint for an Hirose FX2-60P-1,27DSL connector

3D Modeling of Electronic Components

3D Models of Electronic and Electo-Mechanical Componets sourced from the supplier or created by myself are linked to the component footprint or part within the CAD library.

Below shows the STEP file an FX2-60P-1,27DSL downloaded from the Hirose website and linked to the footprint created from scratch.

hirose_fx2-60p-1-27dsl_3d

Hirose FX2-60P-1,27DSL STEP file linked to CAD Library Footprint

Shown below is the 3D model created for an NXP SOT1673-1, Case 1320a-03 MPAK Pressure Sensor that I created from scratch in Solidworks 2016, and was linked to the footprint created in a CAD library.

3D Model created for NXP SOT1673-1 Case 1320a-02 MPAK

3D Model created for NXP SOT1673-1 Case 1320a-02 MPAK

Part Creation

Parts for CAD libraries can created with a full range of attribute information entered for the customer’s requirements including links to manufacturer’s datasheets, temperature ranges, supplier order codes, physical and electrical attributes.

Component Part Library Entry for Hirose FX2-60P-1,27DSL

Component Part Library Entry for Hirose FX2-60P-1,27DSL